Buderus Logano GE515 Installation And Maintenance Instructions Manual page 40

8 Boiler block assembly
Prepare the installation of side panels by initially fitting
the hinged covers (front) of the side panels.
Pre-assemble the hinges of the hinged covers of the
side panels using 2 self-tapping screws each.
Hook the hinge hooks (Fig. 49, [1]) on the hinged
cover of the side panel into the cut-out of the front
side panel and secure with self-tapping screws.
Hook the tensioning spring (Fig. 49, [2]) into the side
panel and the hinged cover of the side panel.
Hook the front side panels (Fig. 50, [2]) into the l.h.
and r.h. bottom of the angled tabs on the plinth rails
(Fig. 50, [1]), then push them at the top over the
angled part of the longitudinal rails.
When the side panels (Fig. 51, [2]) are vertically
aligned, tighten the self-tapping screws (Fig. 51, [4]).
Push the cross plinth rails (Fig. 51, [1] and [3]) from
the front and rear into the longitudinal plinth rails. The
angled part of the cross plate must always be down
and point towards the boiler (Fig. 51).
40 Logano GE515 - We reserve the right to make any changes due to technical modifications.
2
Fig. 49 Install the hinged covers to the side panels
Fig. 50 Hook in the side panel components
1
Fig. 51 Install the plinth rails
1
1
2
2
1
2
3
4