Buderus Logano GE515 Installation And Maintenance Instructions Manual page 32

8 Boiler block assembly
8.8.3 Installing the burner door
Insert a few drops of silicone adhesive every 15 to
20 cm into the packing grooves (Fig. 31, [2]) on the
front section (Fig. 31).
Insert the GP cord into the packing groove on the
front section. Position the butt ends of the packing
cord on the side of the section (Fig. 31, [2]).
At the factory, both hinge eyes are fitted to the r.h. side
of the burner door (Fig. 32, [1] and [2]). To convert to l.h.
hinges, remove the hinge eyes and fit them to the l.h.
side of the burner door.
Secure each hinge pin (r.h. fitting) with 2 x M12 × 55
to the front section (Fig. 31, [1] and [3]). Fit to the l.h.
side for l.h. hinges.
Secure the closure bars with leading edge for the
burner door (r.h. mounting) with 2 x M12 × 55 each to
the front section (Fig. 31, [4] and [5]). Fit likewise to
the r.h. side for l.h. mounting.
USER NOTE
Ensure that the leading edge of the
closure bars are located on the inside
of the boiler.
Hook the burner door with the hinge rings onto the
hinge pins.
32 Logano GE515 - We reserve the right to make any changes due to technical modifications.
5
4
Fig. 31 Installing the hinge hooks and the closure bars
6
5
4
Fig. 32 Hooking in the burner door
1
2
3
3 2 1