Buderus Logano GE515 Installation And Maintenance Instructions Manual page 24

8 Boiler block assembly
Loosen and remove boiler compression tool.
Check nipples for correct seating.
COMPRESSION TOOL DAMAGE
The compression tool may be damaged or
destroyed, if you compress pull rods with
CAUTION!
loose threaded connections.
Before every use of the pull rods, check
and, if necessary, tighten them. The
pull rod is correctly positioned if it is
fully inserted and no thread is showing
(Fig. 20, [2]).
Keep the thread (Fig. 20, [1]) clean.
Contaminated threads can damage the
compression tool during tightening.
Fig. 21 shows the rear section with a fitted centre
section. The assembly is already prepared for the
installation of the next centre section.
The boiler section was levelled with boiler section base
wedges (Fig. 21, [1]) to simplify the installation.
The boiler section base wedges are later used for final
levelling the completed boiler block.
Assemble all other boiler sections as described. The
front section is assembled last.
DANGER OF INJURY
through falling boiler sections.
CAUTION!
Only remove the installation template
when at least three boiler sections have
been assembled.
24 Logano GE515 - We reserve the right to make any changes due to technical modifications.
1
Fig. 20 Boiler compression tool size 2.3
Fig. 21 Use boiler section base wedges
2
1
1