Buderus Logano GE515 Installation And Maintenance Instructions Manual page 35

8.9.2 Installing the tie-bars
Secure the upper front cross tie-bars (Fig. 37, [2]) by
hand on the cast lugs (Fig. 37, [1] and [4]) using
hexagon screws (M8 × 16). The edge of the front tie-
bar must point to the front.
Secure the upper rear cross tie-bars (Fig. 37, [3]) on
the cast lugs using hexagon screws (M8 × 16). The
edge of the rear tie-bar must point to the rear.
USER NOTE
You can only align the longitudinal rails or
mounting brackets before locating the
thermal insulation.
Correctly align the longitudinal rails or
mounting brackets for the later
installation of the side panels, covers
and the thermal insulation.
Locate the longitudinal rails (Fig. 38, [1] and [2]) on
both mounting brackets on the rear and front
sections.
Push the longitudinal rails with pre-fitted screws
(Fig. 38, [3]) into the mounting bracket recesses
(Fig. 38, [4]) and secure using these screws.
Logano GE515 - We reserve the right to make any changes due to technical modifications.
Boiler block assembly
2
1
Fig. 37 Installing the cross tie-bars
1
Fig. 38 Installing the longitudinal rails
8
3
4
2
3
4
35