Assignment Of The Line Filters To The Ui Modules - Siemens SIMODRIVE 611 Planning Manual

05.01
7.2.2

Assignment of the line filters to the UI modules

Table 7-11 Assignment of the line filter to the UI modules
Filter components Line filter, 5 kW
Order No., 6SN1111–0AA01–1BA0
Mounting position Any
Module width Refer to Dimension Drawings, Section 12
Filter Filter 3.8 kg
I filter 16 A
rated
P filter 20 W
v
Connection 4 mm
PE, M6 studs
Terminals, LINE
Line supply input L1, L2, L3, PE
Terminals, LOAD
output L1, L2, L3, PE
1)
I fuse 16 A
rated
Cooling Non–ventilated
Radio interference suppres- Cable–borne,
sion limit value Class A
EN 55011
1) The fuse used must have this rated current. Refer to Table 7-1 for recommended fuses.
7.2.3 Adapter set and line filter package
Line filter packages are available for the I/R modules (refer to Catalog NC60).
These line filter packages comprise a line filter and an HF commutating reactor
(refer to Table 7-10).
We recommend that these line filter packages are ordered.
Adapter sets are available to adapt the line filter packages to the mounting sur-
face and to the retaining points of the earlier filter modules. The mounting depth
protrudes beyond the front of the drive group by 20 – 30 mm.
Note
It is not permissible that the filter inputs and outputs are interchanged.
 Siemens AG 2001 All rights reserved
SIMODRIVE 611 Planning Guide (PJU) – 05.01 Edition
7.2 Line filter and HF commutating reactors for I/R and UI modules
UI module
5/10 kW
Line filter, 10 kW
6SN1111–0AA01–1AA0
5.7 kg
25 A
20 W
2
10 mm
PE, M6 studs
LINE
L1, L2, L3, PE
LOAD
L1, L2, L3, PE
25 A
Non–ventilated
Cable–borne,
limit value Class A
7 Line Supply Connection
UI module UI module
10/25 kW
Line filter, 28 kW
6SN1111–0AA01–1CA0
12.5 kg
65 A
25 W
2 2
50 mm
PE, M10 studs
LINE
L1, L2, L3, PE
LOAD
L1, L2, L3, PE
80 A
Non–ventilated
Cable–borne,
limit value Class A
28/50 kW
J
7-215
7