5.5 Induction Motor Control With Analog Setpoint Interface 6Sn1122-0Ba1_-0Aa - Siemens SIMODRIVE 611 Planning Manual

5 Control Modules
5.5 Induction motor control with analog setpoint interface 6SN1122–0BA1_–0AA_
5.5
6SN1122–0BA1_–0AA_
Induction motor
control
5
5-118
Induction motor control with analog setpoint interface
The following appropriate control components are available for standard
induction motors without rotary encoder (Order No. 6SN1122–0BA11–0AA1).
M3 / 0.8 Nm
0.8 Nm
Fig. 5-6 Induction motor control
Note
When using non–PELV circuits at terminals AS1, AS2, connector coding must
be used so that the connectors cannot be interchanged (refer to EN60204–1,
Section 6.4).
Order No. of the coding, refer to Catalog NC 60.
Notice
Only PELV circuits may be connected at connector X432 pin15 (FR–).
X2
X1
M
IR
56 91 A
14 M
24 92 A
8 M
663 289
65 11 A
81 21 A
31 A
E1
41 A
E2
E3 51 A
61 A
E4
E5 672
E6 673
E7 674
E8
E9 AS1
9
AS2
+ –
P
Version label
Software
M3 / 0.8 Nm
 Siemens AG 2001 All rights reserved
SIMODRIVE 611 Planning Guide (PJU) – 05.01 Edition
05.01