Control Module With Option Module - Siemens SIMODRIVE 611 Planning Manual

05.01
5.8.1

Control module with option module

Control module
with optional
PROFIBUS–DP
module
Option module
PROFIBUS–DP3
with PROFIBUS–ASIC
DPC31 with PLL
The following applies for plug connections:
In order that the plug connections with the
same number of pins cannot be incorrectly
inserted, they must be appropriately coded
(refer under the index entry "Coding the
mini connectors").
The following is valid for screws:
Tighten (for shield contact)
Max. torque = 0.8 Nm
Fig. 5-12 "SIMODRIVE 611 universal E" control module with optional PROFIBUS–DP3 module
 Siemens AG 2001 All rights reserved
SIMODRIVE 611 Planning Guide (PJU) – 05.01 Edition
5.8 Control module "SIMODRIVE 611 universal E"
"SIMODRIVE 611 universal E" control module
2–axis for encoders with sin/cos 1Vpp


Module for
encoder evaluation

Slot for
option module
PROFIBUS–DP3

S
Interfaces
S
Terminals
S
Test sockets


Serial interface
(RS232)

Encoder interface for

TTL encoders


Memory module
S
Firmware
S
User data
Display and
operator control unit
Pulse interface
Equipment bus
5 Control Modules


X302


5-137
5