Chrysler Concorde 2004 Service Manual page 1782

8N - 24 POWER WINDOWS
WINDOW SWITCH (Continued)
REAR DOOR SWITCHES
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Open rear door.
(3) Using a trim stick (special tool #C-4755), gently
pry up on rear edge of switch pushing forward as you
pry up on switch bezel.
(4) Pull switch up and out of rear door trim panel.
(5) Using a trim stick, gently pry out on retaining
tabs on side of switch connector and pull connector
from switch.
(6) Remove switch from vehicle.
INSTALLATION
MASTER SWITCH
INTREPID AND CONCORDE
(1) Install switch and wire connector.
(2) Install three mounting screws.
(3) Install drivers door trim panel. (Refer to 23 -
BODY/DOOR - FRONT/TRIM PANEL - INSTALLA-
TION).
(4) Connect negative battery cable remote termi-
nal.
LHS and 300M
(1) Install wire connector to switch.
(2) Install switch to trim panel.
(3) Connect negative battery cable remote termi-
nal.
PASSENGER SWITCH
(1) Install switch and wire connector.
(2) Install door trim panel. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - INSTALLATION).
(3) Connect negative battery cable remote termi-
nal.
REAR DOOR SWITCHES
(1) Install connector to switch.
(2) Insert switch into door trim panel.
(3) Connect negative
terminal.
LH
battery cable remote