Specifications; Transmitter; Remote Keyless Entry Module; Removal - Chrysler Concorde 2004 Service Manual

8N - 6 POWER LOCKS
KEYLESS ENTRY TRANSMITTER (Continued)
Transmitter programming by the customer is done
by continually pressing the unlock button, on a pro-
grammed fob, for a minimum of 4 seconds to a max-
imum of 10 seconds with the ignition switch ON.
Within the 4-10 second range, the panic button is
depressed. Both buttons are then released.
The BCM will chime indicating you have entered
program mode. To program RKE transmitters, press
and hold the RKE Lock and Unlock buttons simulta-
neously for three seconds, then press the Unlock but-
ton. Verify the BCM chimes after each transmitter is
programmed. To exit program mode, turn off ignition
or wait 32 seconds. The BCM will chime again.

SPECIFICATIONS

TRANSMITTER

BATTERY
The transmitter has two 3 volt batteries, which can
be removed and replaced without special tools. Insert
a dime in the side slot of the transmitter and twist.
the halves should separate and the batteries are
stacked on top of each other. The batteries are avail-
able at local retail stores. Recommended batteries are
Panasonic CR 2016 or equivalent. Battery life is
about two years (Fig. 1).
RANGE
Operation range is within 12 meters (40 ft.) of the
module/receiver.
REMOTE KEYLESS ENTRY
MODULE

REMOVAL

The Remote Keyless Entry (RKE) Module is
located between the junction block and body control
module. Refer to Electrical, Electronic Control Mod-
ules, Body Control Module, Removal.
(1) Disconnect and isolate the battery negative
cable.
(2) With the junction block/BCM removed, sepa-
rate the two by removing the four retaining screws.
(3) Unsnap the RKE module from the BCM.

INSTALLATION

(1) Place module into position on BCM and snap
the RKE Module into place.
(2) Attach the junction block/BCM and install the
four retaining screws.
(3) Connect battery negative cable.
Install the BCM. Refer to Electrical, Electronic
Control Modules, Body Control Module, Installation.
NOTE: The RKE transmitters must be repro-
grammed to the new RKE module.
LH