Installation; Side Repeater Lamp Unit - Export Removal; Spot Lamp - Police Removal - Chrysler Concorde 2004 Service Manual

LH
SIDE REPEATER LAMP - EXPORT (Continued)
(2) Reach up behind the side repeater lamp and
depress the two lamp unit retaining tabs. Remove
the lamp unit from the fender opening.
(3) Rotate the side repeater lamp unit counter-
clockwise and remove the lamp socket from the lamp
unit (Fig. 48).
Fig. 48 SIDE REPEATER LAMP/HOUSING
1 - BULB SOCKET
2 - SIDE REPEATER LAMP UNIT
(4) Pull the lamp bulb straight from its socket.

INSTALLATION

(1) Install the side repeater lamp bulb in the
socket.
(2) Verify lamp operation.
(3) Install the side repeater lamp socket into the
lamp unit.
(4) Install the side repeater lamp in the front
fender. Be certain lamp unit is secure in fender.
SIDE REPEATER LAMP UNIT -
EXPORT
REMOVAL
(1) Working in the appropriate front wheel well,
remove the rear most fasteners from the front wheel-
house liner.
(2) Reach up behind the side repeater lamp and
depress the two lamp housing retaining tabs (Fig.
48). Remove the side repeater lamp unit from the
fender opening.
(3) Rotate the side repeater lamp unit counter-
clockwise and remove the lamp socket from the lamp
unit (Fig. 48).
INSTALLATION
(1) Install the side repeater lamp socket into the
lamp unit.
LAMPS/LIGHTING - EXTERIOR 8L - 39
(2) Install the side repeater lamp in the front
fender (Fig. 48). Be certain lamp is secure within the
fender.
(3) Install the front wheelhouse liner.
(4) Verify lamp operation.
SPOT LAMP - POLICE
REMOVAL
(1) Remove the PDC cover and pull either the X or
Y fuse, depending on which spot lamp is being ser-
viced.
(2) Raise the spot lamp from the stowed to the
operating position.
(3) Support the spot lamp sealed beam in position.
(4) Remove the screws retaining the bezel to the
spot lamp head assembly (Fig. 49).
Fig. 49 SPOT LAMP RETAINING SCREWS -
REMOVE/INSTALL
1 - SPOT LAMP HEAD ASSEMBLY BEZEL RETAINING SCREWS
2 - SPOT LAMP
(5) Remove the bezel from the spot lamp head
assembly.
(6) Tilt the sealed beam away from the spot lamp
head assembly.
(7) Disconnect the electrical connector to the spot
lamp head assembly.
(8) Remove the bulb from the lamp housing by
moving the hold downs.
(9) Remove bulb from lamp.
INSTALLATION
(1) Position bulb into spot lamp assembly.
(2) Install the hold downs.