Installation - Chrysler Concorde 2004 Service Manual

8L - 22 LAMPS/LIGHTING - EXTERIOR
HEADLAMP (Continued)
Fig. 28 HID BALLAST MODULE
1 - BALLAST MODULE RETAINING SCREWS
2 - BALLAST MODULE
3 - IGNITER/LAMP ASSEMBLY CONNECTOR
4 - B+ AND B- SUPPLY TO BALLAST MODULE
(4) Disconnect wire connector from back of lamp
socket (Fig. 29).
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(5) Rotate bulb (High beam or Low beam) and pull
from headlamp unit.
Fig. 29 HEADLAMP - INTREPID
1 - LOW BEAM
2 - PARKING AND TURN SIGNAL
3 - HIGH BEAM

INSTALLATION

CONCORDE/300M
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Install the headlamp wiring connector.
(2) Place lamp into socket and rotate retaining
ring (High beam or Low beam) to headlamp housing.
(3) Install the headlamp unit. Refer to Electrical,
Lamps/Lighting - Exterior, Headlamp Unit, Installa-
tion.
HIGH INTENSITY DISCHARGE HEADLAMPS - 300M
SPECIAL
IGNITER/LAMP ASSEMBLY
The igniter and lamp are an assembly and will be
replaced as such. The water shield will also come
with a new assembly.
(1) Place assembly straight into the headlamp
unit.
(2) Install the spring retainer onto the igniter/
lamp assembly.
(3) Start the rubber water shield in the groove,
making sure it is positioned properly and then press
down on the edge to fully seat the lip in the retaining
groove.
(4) Position the retaining ring over the water
shield and install Remove three screws.
(5) Connect the igniter assembly connector into the
ballast module.
(6) Install the headlamp unit (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
LAMP UNIT - INSTALLATION).
BALLAST MODULE
(1) Install the three retaining screws to the ballast
module.
(2) Connect the igniter/lamp connector to the bal-
last module.
(3) Install the headlamp unit (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
LAMP UNIT - INSTALLATION).
INTREPID
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Rotate bulb (High beam or Low beam) and
push into headlamp unit.
(2) Connect wire connector to the back of lamp
socket (Fig. 29).
LH
- EXTERIOR/HEAD-
- EXTERIOR/HEAD-