Operation; Diagnosis And Testing - Headlamp Washer - Export - Chrysler Concorde 2004 Service Manual

LH
HEADLAMP WASHERS - EXPORT (Continued)

OPERATION

The headlamp washer system utilizes a separate
high pressure pump that is attached to the wind-
shield washer reservoir. The headlamp washer pump
feeds four nozzles that are mounted behind the front
fascia of the vehicle. The nozzle bodies have a tele-
scopic action that will extend the nozzles in front of
the headlamp assembly. During the telescopic action,
doors in the fascia will open to allow the nozzles to
advance into the proper spray position. These nozzles
spray the headlamps when the system is activated.
CONDITION
WASHER POWER FEED
FUSE OPEN.
BLOWN FUSE WHEN
WASHER SWITCH IS
DEPRESSED.
WINDSHIELD/HEADLAMP WASHER TEST
POSSIBLE CAUSE
1. JUNCTION BLOCK FUSE
#5 BLOWN.
1. SHORT IN WIPER/
WASHER SWITCH.
2. SHORT IN MOTOR
POWER CIRCUIT.
3. SHORT IN WASHER
MOTOR.
DIAGNOSIS AND TESTING - HEADLAMP
WASHER - EXPORT
Whenever a headlamp washer malfunction occurs,
first verify that the windshield washer wire harness
is properly connected to all connectors before starting
normal diagnosis and repair procedures. Refer to
Windshield/Headlamp Washer Test table.
CORRECTION
1. CHECK FUSE #5. REPLACE IF NOT OK.
1. DEFECTIVE WASHER SWITCH. REFER TO
WIPE/WASHER SWITCH DIAGNOSTIC
PROCEDURES.
2. SHORT OR DEFECTIVE CIRCUIT BETWEEN
WIPER/WASHER SWITCH CONNECTOR
TERMINAL #2 AND MOTOR CONNECTOR
TERMINAL #1. IF NOT OK, REPAIR CIRCUIT.
3. REPLACE WASHER MOTOR.
WIPERS/WASHERS 8R - 9