Installation - Chrysler Concorde 2004 Service Manual

8O - 24 RESTRAINTS
SEAT AIRBAG WIRING HARNESS (Continued)
(5) Disengage seat back trim cover J-strap from
the upper, lower and airbag side of seat back.
(6) Disconnect the side airbag electrical connector.
Slide yellow locking tab down to unlock. Then with
two fingers, push two side retaining tabs in and pull
connector straight from side airbag.
(7) Remove the front seat cushion side shield.
Refer to Body, Seats, Front Seat Cushion Side Shield,
Removal.
(8) Disengage push pin and remove the wire har-
ness (Fig. 28) and (Fig. 29) from the seat assembly.
Fig. 28 SEAT AIRBAG WIRE HARNESS LOCATION
1 - SEAT TRACK RETAINING BOLTS
2 - SEAT AIRBAG WIRE HARNESS
3 - SEAT AIRBAG WIRE HARNESS CONNECTOR
4 - CUSHION PAN

INSTALLATION

(1) Install the airbag wire harness in the seat. Be
certain the wire harness routing is correct. The har-
ness should follow the leading edge of the seat back
frame down into the lower seat cushion. Once
inserted in lower cushion, the harness is positioned
between the cushion pan and the seat track, and
held in place with push pins.
(2) Connect the side airbag electrical connector.
After connector is installed be certain the yellow
locking tab is in the upper "LOCKED" position.
Check to be certain that the connector cannot be
removed once yellow locking tab is positioned.
(3) Install the seat back trim cover J-straps on the
upper, lower, and airbag side of the seat back frame.
Fig. 29 SEAT AIRBAG WIRING HARNESS
1 - YELLOW CONNECTOR LOCK
2 - TO AIRBAG MODULE
3 - TO BODY HARNESS
CAUTION: Always install new push pins when
installing the seat back plastic panel.
(4) Install the plastic back panel on the seat back.
Install new push pins in the upper mounting location
of the back cover. Refer to Body, Seats, Front Seat
Back Cover, Installation.
(5) Install the front seat cushion side shield. Refer
to Body, Seats, Front Seat Cushion Side Shield,
Installation.
WARNING: BE CERTAIN PLASTIC BACK COVER IS
SECURELY INSTALLED ON THE SEAT BACK. FAIL-
URE TO DO SO WILL ADVERSELY AFFECT THE
FUNCTIONALITY OF THE SIDE AIRBAG SYSTEM.
(6) Install the left front seat in the vehicle. Refer
to Body, Seats, Front Seat, Installation.
WARNING: DO NOT CONNECT THE BATTERY NEG-
ATIVE CABLE REMOTE TERMINAL. REFER TO
ELECTRICAL, RESTRAINTS, DIAGNOSIS AND TEST-
ING - AIRBAG SYSTEM FIRST.
LH