Rear Axle Shaft Oil Seal
REMOVAL
1) Remove rear axle shaft. For details, refer to steps 1) to 8) of
"REAR AXLE SHAFT AND WHEEL BEARING" in this sec-
tion.
2) Remove rear axle shaft oil seal (1) by using special tool.
Special tool
(A) : 09913-50121
2. Axle housing
INSTALLATION
1) Using special tool, drive in new oil seal (1) until it contacts oil
seal protector (2) in axle housing.
NOTE:
• Make sure that oil seal is free from inclination as it is
installed.
• Refer to figure so that oil seal is installed in proper
direction.
Special tool
(A) : 09944-67010
(B) : 09924-74510
"A" : Grease 99000-25010
A : Differential side
2) For procedure hereafter, refer to steps 4) to 16) of "REAR
AXLE SHAFT AND WHEEL BEARING" in this section.
REAR SUSPENSION 3E-3