Suzuki WagonR+ RB310 Service Manual page 1336

REMOVAL
Remove rear seat belts referring "Component" under "Rear Seat Belt" in this section.
INSPECTION
• Check the rear seat belt in the same way as "INSPECTION" of "FRONT SEAT BELT", in this section.
• As to seat belts with A-ELR, check them as follows in addition to above check.
– With vehicle at stop, pull seat belt all the way out, let it retract a little and try to pull it. It should not be
pulled out, that is, it should be locked where retracted.
– Let seat belt retract to its original state. Next, pull it half way out, let it retract a little and try to pull it again.
It should be pulled out smoothly, that is it should not be locked at this time.
INSTALLATION
Install in reverse order of removal, noting the following.
• Seat belt anchor bolts should have an unified fine thread (7/16-20 UNF). Under no circumstances should
any different sized or metric screw threads be used.
Upper and lower anchor bolt
Retractor assembly bolt
Retractor assembly screw
Front seat belt buckle mounting bolt
Rear seat belt, rear center seat belt buckle mounting bolts
Rear center seat belt connector mounting bolt
Tightening Torque Specification
Fastening part
Tightening torque
N•m kg-m
45 4.5
45 4.5
3.5 0.35
35 3.5
45 4.5
45 4.5
SEAT BELT 10A-3
lb-ft
32.5
32.5
2.55
25.5
32.5
32.5