Monitoring The New Recorded Sound - Sony DCR- TRV24E Operating Instructions Manual

Audio dubbing
Monitoring the new recorded
sound
(1) Play back the tape on which you added audio.
(2) Press MENU, then select AUDIO MIX in
1) 2)
* / * with the SEL/PUSH EXEC dial
(p. 236).
(3) Turn the SEL/PUSH EXEC dial to adjust the
balance between the original sound (ST1) and
the new sound (ST2), then press the dial.
Five minutes after you disconnect the power
supply or remove the battery pack, the
AUDIO MIX setting returns to original sound
(ST1) only. The default setting is original
sound only.
Notes
•New audio cannot be recorded on a tape
already recorded in the 16-bit mode (32 kHz,
44.1 kHz or 48 kHz).
•New audio cannot be recorded on a tape
already recorded in the LP mode.
•You cannot add audio with the AUDIO/
1)
VIDEO OUT jack.*
•You cannot add audio with the DV OUT*
2)
DV IN/OUT* jack.
•You cannot add audio on the blank portion of
the tape.
If an i.LINK cable (DV connecting cable)
(optional) is connected to your camcorder
You cannot add audio to a recorded tape.
We recommend that you add audio on a tape
recorded with your camcorder
If you add audio on a tape recorded with another
camcorder, the sound quality may become
worse.
If you set the write-protect tab of the cassette
to lock
You cannot record on a tape. Slide the write-
protect tab to release the write protection.
1)
* DCR-TRV16E/TRV18E/TRV24E only
2)
* DCR-TRV25E/TRV27E/TRV116E/TRV118E
only
(1)
(2)
VCR SET
HiFi SOUND
AUD I O M I X
A / V DV OUT ST1 ST2
NTSC PB
RETURN
[ MENU ] : END
(3)
1)
or
1)
2)
1) 2)
1)
1) 2)
129