Adding An Audio Sound On A Recorded Tape; Monitoring The New Recorded Sound - Sony DCR-TRV17 Operating Instructions (primary manual) Operating Instructions Manual

Audio dubbing

Adding an audio sound on a recorded tape

(1) Insert the recorded tape into your camcorder.
(2) Set the POWER switch to VCR on your camcorder.
(3) Locate the recording start point by pressing N on the Remote Commander.
Then press X at the point where you want to start recording to set your
camcorder to the playback pause mode.
(4) Press AUDIO DUB. The green
(5) Press X on your camcorder and start playing back the audio you want to
record at the same time.
The new sound is recorded in stereo 2 (ST2) during playback.
(6) Press x on your camcorder at the point where you want to stop recording.

Monitoring the new recorded sound

To play back the sound
Adjust the balance between the original sound (ST1) and the new sound (ST2) by
selecting AUDIO MIX in
Five minutes after when you disconnect the power source or remove the battery pack,
the setting of AUDIO MIX returns to the original sound (ST1) only. The default setting
is original sound only.
X indicator appears on the screen.
AUDIO DUB
in the menu settings (p. 98).
VCR SET
H i F i SOUND
AUD I O M I X
A / V DV OUT ST1 ST2
RETURN
[ MENU ] : END
87