Sony DCR- TRV24E Operating Instructions Manual page 128

Audio dubbing
Adding audio on a recorded
tape
Choose a connection described on the previous
pages, and connect audio equipment or
microphone to your camcorder. Then follow the
procedure below.
(1) Insert the recorded tape into your camcorder.
(2) Set the POWER switch to VCR on your
camcorder.
(3) Locate the recording start point by pressing
N. Then press X at the point where you
want to start recording to set your camcorder
to the playback pause mode.
(4) Press AUDIO DUB
indicator appears on screen.
(5) Press X on your camcorder and start playing
back the audio you want to record at the same
time.
The new sound is recorded in stereo 2 (ST2)
during playback. During recording new
sound, the red
(6) Press x on your camcorder at the point where
you want to stop recording.
To add audio more precisely
Press ZERO SET MEMORY on the Remote
Commander at the point where you want to stop
recording later in the playback mode.
Carry out steps 3 to 5. Recording automatically
stops at the point where ZERO SET MEMORY
was pressed.
128
. The green X
appears on the screen.
(1)
(2)
(3)
X
(4)
(5)
(6)
AUDIO DUB
N
X
x
X