Sony DCR- TRV24E Operating Instructions Manual page 53

Playing back a tape
[a] Tape counter
[b]SteadyShot OFF
[c] Exposure mode
[d]White balance
[e] Gain
[f] Shutter speed
[g]Aperture value
To not display various settings
Set DATA CODE to DATE in the menu settings
(p. 242).
The display changes as follows when you press
DATA CODE on the Remote Commander:
date/time y no indicator
Various settings
Various settings are your camcorder's
information when you have recorded. In the
recording mode, the various settings will not be
displayed.
When you use the data code function, bars
(-- -- ----) appear if:
– A blank portion of the tape is being played
back.
– The tape is unreadable due to tape damage or
noise.
– The tape was recorded by a camcorder without
the date and time set.
Data code
The data code is displayed on the TV screen if
you connect your camcorder to the TV.
Remaining battery time indicator during
playback
The indicator shows the approximate continuous
playback time. The indicator may not be correct,
depending on the conditions in which you are
playing back. When you close the LCD panel and
open it again, it takes about one minute for the
correct remaining battery time to be displayed.
Date/time/
50min
0:00:23:01
JU4 7 2002
12:05:56 PM
Various settings/
[a]
50min
0:00:23:01
[b]
[c]
[d]
AUTO
50 AWB
[e]
F2.0 9dB
[f]
[g]
[a]
[b]
[c]
[d]
[e]
[f]
[g]
y
-- -- ----
53