Operation By Sd Memory Card - Panasonic ELC500 User Manual

7.4

Operation by SD Memory Card

■Operation of a project saved in SD memory card
Insert SD memory card, set Mode switch to 'RUN', set Card operation switch to 'CARD' to enable the
operation of a project saved in SD memory card.
■Switch setup
Mode switch
Card operation switch
STOP/
PROG.
RUN
COPY
■Procedure
1. Power off ELC500.
2. Insert SD memory card that it saves auto execution file 'autoexec.fp7' and comment file 'comment.fp7'
of a project to be used for operation.
3. Set Card operation switch to 'CARD'.
4. Close Cover and power on ELC500.
Auto execution file 'autoexec.fp7' and comment file 'comment.fp7' of a project saved in SD memory
card, are transmitted to the execution memory RAM.
It transmits the project when ELC500 powered on or it change mode to 'RUN'.
Note
During it operates by SD memory card, it is impossible to RAM/ROM operation until power
off ELC500.
RUN
CARD
163
ELC500 Control unit