Panasonic ELC500 User Manual page 125

Item
(a) Communication I/F
(b) Connection device
(c) ON/OFF
Ex.)
No alarm: It makes ON all output
When alarm 1: It makes ON OUT1 and OUT2
When alarm 2: It makes ON OUT1.
When alarm 3: It makes OFF all output
Note
- It can't set COM0 for communication I/F of remote I/O unit.
- In case of setting remote I/O unit to remote I/O output, when it shifts RUN mode to
STOP/PROG mode, ELC500 writes output status with no alarm to the registered remote
I/O unit.
(a)
(b)
(c)
Description
Set communication I/F that is connected remote I/O unit.
<Set range>COM1 / COM2
Set registered remote I/O.
Set remote I/O unit output working for each alarm level.
With check: ON
Without check: OFF
117
ELC500 Control unit