Panasonic ELC500 User Manual page 139

Item
(a) No.
(b) Name
(c) Control trigger
(d) Alarm 3 control time [time A] Set time to output control for alarm level 3.
(e) No alarm control time
[time B]
(f) Control cycle [time C]
(g) Remote I/O output
(h) Group
*1 It doesn't start 'Cyclic control' without the trigger.
Point
- Cyclic control is controlled by output pattern of remoter I/O unit for alarm 3 and no alarm.
In order to use start control, set remote I/O unit so that it power off at alarm 3 and it power
on at no alarm.
Note
- When the same trigger is selected, a trigger with smaller registered number has a priority.
- In case of setting remote I/O unit to remote I/O output, when it shifts RUN mode to
STOP/PROG mode, ELC500 writes output status with no alarm to the registered remote
I/O unit.
Description
Set from 1 to 4.
Set Name
<Set range> 32-letter or less
*1 Set trigger to start 'Cyclic control'.
Select from triggers of appointed period,
monitor data (relay), monitor data (register).
<Set range> 1 to 60[min]
Set time to cancel alarm.
<Set range> 1 to 60[min]
Set time to start next group.
<Set range> 1 to 60[min]
Shift to Remote I/O unit setup window.
Register I/O device before this.
Register control group for I/O devioces.
Set order to control when it start 'Cyclic control'.
N/A
Group 1
Group 2
Group 3
Group 4
131
Remove the target of cyclic control.
Output status = No alarm
Register remote I/O unit in group 1
Register remote I/O unit in group 2
Register remote I/O unit in group 3
Register remote I/O unit in group 4
ELC500 Control unit