Panasonic ELC500 User Manual page 197

Code Name
Copy failure: Cover
40
open
Copy failure: No SD
41
memory card
Copy failure: SD
memory card reading
42
error
(FAT / file error)
43 Copy failure: No file
Copy failure: Password
mismatch
44
(limited distribution
function)
Copy failure: Invalid
45
project data
SD operation
50 impossible
Cover open
SD operation
51 impossible
No SD memory card
SD operation
impossible
52 SD memory card
reading error
(FAT / file error)
SD operation
53 impossible
No file
SD operation
impossible
54 Password mismatch
(limited distribution
function)
SD operation
55 impossible
Invalid project data
Duplicated or
60 exceeded collected
maps
Duplicated or
61 Exceeded registered
I/O maps
62 Interrupt error 1
63 Interrupt error 2
(Note) For errors where "Auto clear" is indicated in the 'Operation' column, error clearance is executed
when power supply is cut off, or when the same operation is executed again after the status has
been corrected.
Operation
Stop The card cover is open and the copy process cannot be
Auto clear executed. Close the cover.
Stop Copying cannot be executed because there is no SD memory
Auto clear card. Insert an SD memory card.
Stop Copying cannot be executed because the SD memory card is
Auto clear damaged. Insert a normal SD memory card.
Stop Copying cannot be executed because there is no file in the SD
Auto clear memory card. Check if a project file is saved in the card.
Copying cannot be executed because the password for the
Stop project file saved in the SD memory card is not consistent with
Auto clear the password for the execution project saved in the built-in
ROM. Check the password settings.
Copying cannot be executed because an error has been
Stop
identified in project data saved in the SD memory card. Check
Auto clear
the project data.
Stop SD memory card operation cannot be executed because the
Auto clear card cover is open. Close the cover.
Stop SD memory card operation cannot be executed because there
Auto clear is no SD memory card. Insert an SD memory card.
SD memory card operation cannot be executed because the
Stop
SD memory card is damaged. Insert a normal SD memory
Auto clear
card.
SD memory card operation cannot be executed because there
Stop
is no file in the SD memory card. Check if a project file is saved
Auto clear
in the card.
SD memory card operation cannot be executed because the
Stop password for the project file saved in the SD memory card is
Auto clear not consistent with the password for the execution project
saved in the built-in ROM. Check the password settings.
SD memory card operation cannot be executed because an
Stop
error has been identified in project data saved in the SD
Auto clear
memory card. Check the project data.
Stop There is an error with I/O maps that have been collected in the
I/O
Auto clear CPU unit. Verify the registered data.
Stop There is an error with I/O maps that have been registered in
Auto clear the CPU unit. Verify the registered data.
Stop There may be a hardware problem. Please contact your
Auto clear dealer.
Stop The interrupt program definition by INTPG instruction may be
Auto clear disappeared by rewriting during RUN. Check the program.
189
Error contents and steps to take
ELC500 Control unit