Panasonic ELC500 User Manual page 147

■LAN port
Item
Computer settings
1
IP address
ELC500 settings
2
IP address
3 Port No.
4 Connection timeout
5 Receive timeout
6 Searching ELC500
Note
- Set ELC500 to STP/PROG mode when it transmits data.
- When ELC500 and PC are on a different network group, it can be searched but it can't be
set. It is necessary to change IP address of ELC500 or PC.
- Set port No. to the same as setting port No. at Ethernet system connection.
Refer to 5.6.1 Basic Configuration.
Description
IP address of PC is displayed.
When 2 or more addresses are set, select one.
Set IP address of connected ELC500.
Set port number of connected ELC500.
Set timeout to use for cut the connection when no
connection.
<Initial> 10 sec.
<Set range>10 / 15 / 20 / 25 / 30 / 35 / 40 / 45 / 50 / 55 / 60
Set timeout to use for cut the connection from sending
command to receiving a response
<Initial> 10 sec.
<Set range>10 / 15 / 20 / 25 / 30 / 35 / 40 / 45 / 50 / 55 / 60
Search ELC500 on network.
After searching ELC500, select unit to readout or write data.
139
ELC500 Control unit
1
2
3
4
5
6