Analog Output Module Error Types - Siemens SIMATIC ET 200S Manual

Analog output module error types

Table 6-15 Analog output module error types
Analog output
modules
2AO U 2AO I
Standard Standard
2AO U 2AO I
High High
Feature Feature
------
------ 2AO I
Standard
2AO I
High
Feature
1SSI
Table 6-16 1SSI
Error type
1 00001: Short-circuit
D
9 01001: Error
D
16 10000: Parameter
D
assignment error
26 11010: External error/fault
D
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Error type
16 10000:
D
Parameter
assignment
error
9 01001: Error
D
1 00001:
D
Short-circuit
6 00110: Wire
D
break
Short circuit of the supply to the
absolute position encoder.
Internal module error occurred.
Load voltage from the power
module is too low.
Parameters have not been
assigned to the module.
Start/stop bit error (absolute
sensor error): Wire break in the
sensor cable or sensor cable is
not connected. Sensor type,
transmission rate, and monoflop
time do not correspond to the
sensor connected;
programmable sensors do not
correspond to the settings on the
1SSI EM. Sensor is defective or
there are faults.
Commissioning and Diagnostics
Meaning
Module cannot use the
parameter for the channel:
Inserted module does not
match the one configured.
Parameter assignment error.
Internal module error has
occurred (diagnostic
message on channel 0
applies to the whole
module).
Short circuit of the actuator
supply.
Line to the actuator
interrupted.
Meaning
Remedy
Correct the configuration
(compare actual and
desired configuration).
Correct the parameter
assignment (parameter
assignment of wire break
diagnosis only with the
permitted measuring
ranges).
Replace the module.
Correct the process wiring.
Correct the process wiring.
Remedy
Correct the process wiring.
Replace the module.
Correct the process wiring.
Check the load voltage.
Adjust the parameter
assignment.
Replace the sensor; correct the
process wiring.
Correct the parameter settings
6-43