Parameters For The Im151-1 Standard And Im151-1 Fo Standard Interface Modules - Siemens SIMATIC ET 200S Manual

Interface Modules
Parameters for the IM151-1 STANDARD and IM151-1 FO STANDARD interface
modules
Table 8-2
IM151-1 STANDARD/IM151-1
FO STANDARD
DP interrupt mode
Bus length
Operation with Set and <>
Actual Configuration
Diagnostic interrupt
Process interrupt
Insert/Remove module
2) 3)
interrupt
Module diagnosis
Module status
Channel-specific diagnostics
Option handling, general
Option handling: Slots 2 to 63
Analog-value format
Interference Frequency
Suppression
Reference junction slot
Reference junction input
1)
Note also the option handling parameters (see Chapter 3.8).
2)
In the device database file, the default setting of the parameter is "Disable".
3)
Only configurable in DPV1 mode.
4)
The default settings are applicable for the default startup (if no other parameters are specified
by the DP master).
8-2
Parameters for the IM151-1 STANDARD and IM151-1 FO STANDARD interface
modules
DPV0/DPV1
≤ 1 m / > 1 m
Disable/enable
1)
3)
Disable/enable
3)
Disable/enable
Disable/enable
Disable/enable
Disable/enable
Disable/enable
Disable/enable
Disable/enable
SIMATIC S7/
SIMATIC S5
50 Hz/60 Hz
None/2 to 63
RTD on channel 0/
RTD on channel 1
Value range Default
DPV0
≤1 m
Disable
disable
disable
disable
enabled
enabled
enabled
disable
disable
S7
50 Hz
none
0
4)
Applicability
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S
Module
ET 200S
ET 200S
ET 200S
ET 200S
ET 200S Distributed I/O System
EWA-4NEB 780602402-12