Response Of Analog Output Module - Siemens SIMATIC ET 200AL Manual

7.2

Response of analog output module

Display
The channel status LEDs are not affected by PROFIenergy.
Response to error detection
All channels that are in pause mode on "PE_MODE_PROCEED" report their diagnostic
status as in productive mode.
The following conditions apply to all channels which switch to the pause mode
"PE_MODE_SHUTDOWN":
● "Wire break" and "Short circuit" error detection is not possible during the pause:
– Alarms for errors already pending before the "pause" are retained.
– Incoming and outgoing errors are reported once the "pause" has ended.
The following applies for all channels which switch to a different pause mode:
● "Wire break" and "Short circuit" error recognition is possible during the pause. These
errors are reported.
● The selection of an incorrect pause substitute value which does not correspond to the
output range may result in the message "High limit violated" or "Low limit violated". The
pause substitute output value effective at the channel is limited to the high or low control
limit for the output range.
Analog output module AQ 4xU/I 4xM12 (6ES7145-5ND00-0BA0)
Manual, 07/2019, A5E38687953-AB
7.2 Response of analog output module
PROFIenergy
29