Analog Output Module Et 200C; Ao; Bit (6Es7 145-0Hf00-0Xb0) - Siemens SIMATIC ET 200C Manual

3.7

Analog Output Module ET 200C; AO 4

(6ES7 145-0HF00-0XB0)
Characteristics
The analog output module ET 200C; AO 4
characteristics:
ET 200C Distributed I/O Station
EWA 4NEB 812 6119-02b
Degree of protection IP 66/IP 67 (see Installation Rules, Section 4.1)
Choice of the following baud rates: 9.6; 19.2; 93.75; 187.5; 500 and
1500 kbaud
Output ranges selectable separately for each channel group
– 10 V
– 0 ... 10 V
– 20 mA
– 0 ... 20 mA
– 4 ... 20 mA
Channel diagnostics of outputs for wire break, range overshoot,
common-mode voltage overshoot, short-circuit and parameterization error
(can be switched off with COM ET 200, see Section 5.1.4).
Channel diagnostics can be evaluated only via the IM 308-C master
interface. Each diagnostics message causes the "DIA" LED to light up.
LEDs for
– RUN
– BF (bus fault)
– DIA (module diagnostics)
No need to open the cover to secure the module (see drill-hole templates
at the back of the manual).
ET 200C Components
12 Bit
12 bit has the following
3-15