Terminal Assignment Of The Tm-P30S44-A0 And Tm-P30C44-A0 Terminal Module - Siemens SIMATIC ET 200S Manual

Terminal assignment
See the following table for the terminal assignment of the terminal module:
Table 9-6
A A A A
8 8
4
2
3 3
A
4
Caution
!
If high currents are encountered at DO 2 P and DO 2 M, terminals 11 and 15
(DO 2 P) and 12 and 16 (DO 2 M) must be wired in parallel.
Otherwise terminal overheating caused by the current load cannot be excluded.
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Terminal assignment of the TM-P30S44-A0 and TM-P30C44-A0 terminal
module
View Terminal
2 24 VDC
3 M
A4 AUX 1
1
9 9
3
6 24 VDC
1 1
6
0 4
1 1
7 1 7
1 5 5
7 M
A
1 1 1 1
8
A8 AUX 1
2 6
9 DO 0 P
10 DO 0 M
11 DO 2 P
12 DO 2 M
13 DO 1 P
14 DO 1 M
15 DO 2 P
16 DO 2M
Name
24 VDC load voltage for: inserted
power module, associated potential group.
DO 0 and DO 1 and P1 and P2 potential
rails
Chassis ground
Any terminal for PE or potential rail up to
the maximum rated load voltage of the
module
24 VDC load voltage for: inserted
power module, associated potential group.
DO 0 and DO 1 and P1 and P2 potential
rails
Chassis ground
Any terminal for PE or potential rail up to
the maximum rated load voltage of the
module
Terminals for fail-safe digital output 0 g
(P--M switching) (P M i hi )
Terminals (relay contacts) for fail-safe
switching of the P1 and P2 potential rails.
P1 and P2 can also be used as DO 2 M P1 and P2 can also be used as DO 2 M
and DO 2 P (for wiring diagram see
ET 200S Manual, Fail-safe Modules).
Terminals for fail-safe digital output 0 (P--M g
switching) i hi )
Terminals (relay contacts) for fail-safe
switching of the P1 and P2 potential rails.
P1 and P2 can also be used as DO 2 M P1 and P2 can also be used as DO 2 M
and DO 2 P (for wiring diagram see
ET 200S Manual, Fail-safe Modules).
Terminal Module
p
p (
9-13