Parameters For 4Di Namur - Siemens SIMATIC ET 200S Manual

Parameters for 4DI NAMUR

Table 11-2 Parameters for 4DI NAMUR
4DI NAMUR 4DI NAMUR 4DI NAMUR
Diagnostic alarm
Sensor type
Pulse stretching
Diagnostics
No sensor power supply
Wire break diagnostics
Short-circuit diagnostics
Flutter monitoring:
1)
Monitoring window
Flutter monitoring:
Number of signal changes
1)
Parameters can only be set if the number of signal changes for flutter monitoring is enabled
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Value range V l Value range g
•
enabled
•
disable
•
Channel disabled
•
NAMUR sensor
•
Single contact
without load resistance
•
Single contact with 10 kΩ
with load resistance
•
NAMUR changeover
contact
•
Changeover contact
without load resistance
•
Changeover contact with
10 kΩ
with load resistance
•
No
•
0.5 s
•
1 s
•
2 s
•
enabled
•
disable
•
enabled
•
disable
•
enabled
•
disable
•
0.5 s
•
1 s to 100s (can be set in
1 s increments)
•
disable
•
2 to 31
Digital Electronic Modules
Default setting Default setting D f l i g Effective range Eff Effective range
disable Module
disable Channel
No Channel
disable Module
disable Channel
disable Channel
0.5 s Channel
disable Channel
i g
11-3