Parameters For Digital Output Modules - Siemens SIMATIC ET 200S Manual

Digital Electronic Modules

Parameters for digital output modules

Table 11-3 Parameters for digital output modules
2DO 24 2DO 24- -230
VDC/ VAC/
0.5A High 1A
Feature
2DO 24 2RO NO
VDC/ 24- -120 VDC/
2A High 5 A 24- -230
Feature VAC/
5 A
Response at CPU/master STOP
1)
Substitute value
Diagnosis:
2)
Wire break
Diagnosis:
Short circuit
as per M
1)
If the interface module is without power, the digital output module does not output substitute values. Output
value = 0.
2)
Wire break is only detected when the output is switched off.
Process alarm
This parameter enables the process interrupts for the module.
Input delay
Signal interference can be suppressed with this parameter. Changes in the signal
are only detected after the specified time.
Trigger for process interrupt, rising edge
This parameter can be used in channels to enable a process interrupt with a rising
edge (a signal status change).
11-4
2DO/ 4DO
2RO NO NC
24- -48 VDC/5 A
24- -230 VAC/5 A
2DO/ 4DO
------
------
------
24 VDC/
0.5 A ST
Value range
24 VDC/
2 A ST
•
------ apply
substitute
value
•
hold last
value
•
------ "0"
•
"1"
•
disable
•
enabled
•
disable
•
enabled
•
disable
•
enabled
ET 200S Distributed I/O System
Default Effective
setting tti range
apply Module
substitute
value
"0" Channel
disable Module
disable Channel
disable Channel
EWA-4NEB 780602402-12