Intermatic InTouch CA5500R User Manual page 9

NOTE: The battery pack is initially unplugged to
preserve battery life. Remove the battery cover and
plug in the battery. Replace the battery cover. The
Hand-Held must have its battery installed and be
properly charged before being used. Place the remote
in the Base. The Power light on the Base will pulse
blue when charging, then change to solid blue when
the Hand-Held is fully charged and ready to use.
1. Place the Hand-Held in the Base and make sure it is
powered ON.
2. While the Hand-Held is in the Base, press and hold
simultaneously the
until the Power Light on the Base lights up with a
pink color.
3. Wait for the pink light to go off.
4. Reset controllers as follows:
NOTE: Unless resetting the entire system, controllers
should not be reset. Instead, simply remove them
from the network. See page 16.
HAND-HELD CONTROLLER—
a. Press and hold simultaneously the
<ENTER>
Light on the Hand-Held lights up with a pink
color.
b. Wait for the pink light to go off.
IN-WALL SCENE/GROUP CONTROLLER—
a. Press and hold
simultaneously the
<ENTER>
buttons until the Status
Light on the Hand-Held
lights up with a pink
color.
b. Wait for the pink light to go off.
Providing a brighter solution.™
Setting Up Your Network
and
<RAISE>
and buttons until the Status
<HOME>
,
<>
and
<HOME>
buttons
<LOWER>
,
<>
<HOME> <HOME>
button button

STATUS STATUS
LIGHT LIGHT