Intermatic InTouch CA5500R User Manual page 27

Programming Scenes with Routing Slave Devices
want to delete. The Status Light on the device will
pulse once slowly with a blue light. This indicates
that the button is in "learning" mode.
NOTE: At this point the scene is deleted.
3. Press and hold (for approximately 10 seconds)
the button that controls the scene being deleted.
The Status Light will stay on while the controller is
gathering information, and will then blink RED once
if deletion is successful.
4. Test the programming. Press the
button once to select the scene, then press the
button to activate the scene. None of the
<ENTER>
components previously associated with the scene
should respond.
If the system includes a In-Wall Master Controller,
the display panel will no longer list the scene.
NOTE: It may take up to 24 hours for the In-Wall Master
Controller to update itself to these changes and show
them on its display panel. To force a faster update,
perform another "Include" procedure with the In-Wall
Master Controller. See page 14.
Providing a brighter solution.™
<SCENE SELECTION>