Adding Devices To The Network - Intermatic InTouch CA5500R User Manual

1
InTouch™ User Guide

Adding Devices to the Network

When including devices,
work in ever-widening
circles away from the
centrally-located Base.
1. Remove the Hand-Held
from the Base and take it
to the first device to be
included in the network.
2. Hold the Hand-Held
within a few feet of the
device to be included.
3. Make sure the lights under the Hand-Held's buttons
are lit. If they are not lit, press any button to wake
the Hand-Held from battery-saving sleep mode.
4. Perform the following procedure and repeat for each
device to be included:
a. Press and release the
Hand-Held. The Status Light lights up blue,
indicating that it is in Include mode.
NOTE: If the Hand-Held Status light blinks
RED immediately upon pressing the
button then the Base and Remote have not
been properly linked together. If this happens,
reset Base and Remote and try again. See
page 9.
a. Press the
included. The Status Light on the Hand-Held will
blink off briefly when it has received the device
being added. When finished, the Status Light on
the Hand-Held will:
- Blink BLUE once if the procedure is
successful.
- Blink RED once if the procedure failed. If this
happens, try again. If it fails a second time,
refer to the Troubleshooting Section of this
Manual for additional information.
Copyright © 2006 Intermatic, Inc.
<INCLUDE>
button on the device to be
<ACTIVATION>
button on the
<INCLUDE>