Breaking The Link Between A Non-Intouch Routing Slave Device And Other Devices - Intermatic InTouch CA5500R User Manual


InTouch™ User Guide
Breaking the Link between a non-
InTouch Routing Slave Device and
Other Devices
1. Press and hold (for 4+ seconds) the
on the InTouch Hand-Held. The Status Light on the
Hand-Held will blink with a red light.
2. Now press the
slave device. (In the example, with the motion
sensor and the light switch, press the
button on the motion sensor.) If the device has a
Status Light, it may light at this time.
NOTE: When the link-breaking programming is
finished, the Status Light on the Hand-Held should:
• Blink BLUE once if programming was successful.
• Blink RED once if programming failed. Refer to
the Troubleshooting Section of this Manual for
additional information.
Copyright © 2006 Intermatic, Inc.
button on the routing
<ACTIVATION>
button
<EXCLUDE>
<ACTIVATION>