Setting Up An On/Off Recurring Event; Setting The On Time - Intermatic InTouch CA5500R User Manual


InTouch™ User Guide
.
motion sensor could turn on hallway lights to full
brightness in the early evening, and to only 20%
brightness after midnight (so you're not blinded on
your way to the bathroom).

Setting Up an ON/OFF Recurring Event

A Recurring Event turns a scene ON or OFF, on a
repeating basis, either at:
• Specific times
• "Astronomically" where the ON/OFF times adjust
automatically according to sunrise and sunset
(earlier sunset in winter, etc.)
This step-by-step procedure will guide you through all
types.

Setting the ON Time

An ON/OFF timer event involves two separate routines:
setting the ON first, and then setting the OFF.
During programming, use the
navigate to your selections on the screen. Use the
arrow to advance to the next item.
<RIGHT>
NOTE: If you pause for more than 30 seconds during
the programming procedure, the In-Wall Master
Controller will time out and exit programming mode.
Begin at the InTouch Home
Screen as shown.
1. Press
<ENTER>
displays the Main Menu.
2. Scroll with the
arrows to select
DOWN>
My Events, then press
. The screen
<ENTER>
displays options for working with events.
Copyright © 2006 Intermatic, Inc.
<ARROW>
. The screen
Setup Setup
<UP/
My Events My Events
buttons to
11:25 11:25
TM TM
WIRELESS CONTROLS WIRELESS CONTROLS
My Scenes My Scenes
My Events My Events
Add Event Add Event
Configure Event Configure Event
Rename Event Rename Event
Delete Event Delete Event
a a
11:25a 11:25a
11:25a 11:25a