Adding A New Device To A Scene; Deleting A Scene - Intermatic InTouch CA5500R User Manual


InTouch™ User Guide

Adding a New Device to a Scene

Deleting a Scene

4. Release the
satisfied with the levels.
5. Press the
<SCENE SELECTION>
it or the
<HOME>
The next time you turn on the scene, the lights in the
scene will return to their originally programmed levels.
NOTE: Devices that cannot be dimmed will not respond
to the
<RAISE/LOWER>
If you would like to add another device to an existing
scene, you must recreate the scene from the beginning,
and include the new device in the programming.
If you have the In-Wall Master Controller (Model
CA7100), you can add your new device by editing
the scene. Refer to detailed instructions for this device
provided in Sections 4 and 5 of this guide.
Use one or more of the controllers shown here to delete
scenes that have been created.
<SCENE SELECTION> buttons <SCENE SELECTION> buttons
Hand-Held with Base Hand-Held with Base
1. If using a Hand-Held, make sure the lights under the
Hand-Held's buttons are lit. If they are not lit, press
any button to wake the Hand-Held from battery-
saving sleep mode.
2. Press and hold (for approximately 10 seconds) the
<SCENE SELECTION>
Copyright © 2006 Intermatic, Inc.
<RAISE/LOWER>
button to deselect a group of scenes.
adjustment.
STATUS STATUS
LIGHT LIGHT
<ENTER> <ENTER>
button button
In-Wall Scene/Group Controller In-Wall Scene/Group Controller
button that controls the scene you
button when you're
button again to deselect