Turning A Scene On Or Off - Intermatic InTouch CA5500R User Manual

Step-by-Step with the In-Wall Master Controller
Select Configure Scene,
3.
then press
<ENTER>
screen displays a list of
the scenes programmed
in your system.
4. Select the scene you
want to configure and
press
<ENTER>
displays the list of rooms.
5. Scroll to select a room and press
6. Scroll to select a device
you want to adjust.
7. Press the
<RIGHT/LEFT>
arrows to adjust the value
you want. You will have one of three possibilities:
• For a switch—ON and OFF.
• For a dimmer switch—OFF and a percentage of
ON.
• For a switch not in the scene—three dashes (it
may be added to the scene at this point).
8. When you are satisfied, press the
highlight Save & Close, then press
the procedure. The display returns to the Main Menu
screen, and automatically exits programming mode
in about 30 seconds if there's no activity.

Turning a Scene ON or OFF

During programming, use the
navigate to your selections on the screen. Use the
arrow to advance to the next item.
<RIGHT>
NOTE: If you pause for more than 30 seconds during
the programming procedure, the In-Wall Master
Controller will time out and
exit programming mode.
Begin at the InTouch Home
Screen as shown.
Providing a brighter solution.™
>Configure Scene >Configure Scene
. The
My Scenes My Scenes
>Configure Scene >Configure Scene
Scene 1 Scene 1
. The screen
>Configure Scene >Configure Scene
Scene 1 Scene 1
<ARROW>
Scene 1 Scene 1
Scene1 Scene1
Bathroom 1 Bathroom 1 Bathroom1 Bathroom1
Bedroom 1 Bedroom 1
Bedroom 2 Bedroom 2
.
<ENTER>
Bathroom1 Bathroom1 Bathroom 1 Bathroom 1
Binary Switch 5 Binary Switch 5
Multi Level Switch 3 Multi Level Switch 3
arrow to
<DOWN>
to finish
<ENTER>
buttons to
11:25 11:25
TM TM
WIRELESS CONTROLS WIRELESS CONTROLS

11:25a 11:25a
11:25a 11:25a
OFF OFF
75% 75%
11:25a 11:25a
a a