Removing Devices From The Network - Intermatic InTouch CA5500R User Manual

1
InTouch™ User Guide
Select Setup
c.
Network, then
press
screen displays
options for setting up the network.
d. Select Replicate Receive, then press
The screen will display as follows:
- "Waiting for routing table update..." when
the Replicate Receive command has been
received.
- "Loading routing table..." when the Master
Controller is communicating with the
Base/Hand-Held.
- "Routing table updated" if the update was
successful.
- "Routing table update failed" if the
update was not successful. Refer to the
Troubleshooting Section of this Manual for
additional information.
After a brief delay (up to 30 seconds) the
screen returns to the InTouch Home Screen.
6. Repeat this simple procedure for each device in your
network, working in widening circles from the Base.
When you've included each device, you're done.
Follow the same procedure to include other Z-Wave devices
in the network (i.e., Intermatic HomeSettings™ devices or
devices from other manufacturers). For specific information
on which button to press, refer to the user guide that came
with the device or contact the manufacturer.

Removing Devices from the Network

Use this procedure to remove InTouch devices from
your home network. Before you replace an old device
with a new one, you need to make sure your network
isn't still looking for it.
NOTE: If you are unsure if a device has been used
before, it is always a good idea to "remove" it first.
Copyright © 2006 Intermatic, Inc.
Setup>Setup Network Setup>Setup Network
. The
<ENTER>
Include Node Include Node
Exclude Node Exclude Node
Replicate Receive Replicate Receive
Reset Controller Reset Controller
<ENTER>
11:25a 11:25a
.