Intermatic InTouch CA5500R User Manual page 17

1. Remove the Hand-Held from the Base and take it to
the first device to be removed in the network.
2. Hold the Hand-Held within a few feet of the device
to be removed.
3. Make sure the lights under the Hand-Held's buttons
are lit. If they are not lit, press any button to wake
the Hand-Held from battery-saving sleep mode.
4. Perform the following procedure and repeat for each
device to be included:
a. Press and release the
the Hand-Held. The Status Light lights up red,
indicating that it is in Exclude mode.
b. Press the
excluded.
NOTE: On InTouch devices that have this feature,
the status light will begin blinking BLUE and/or RED
to indicate that the device is ready to be removed
from the network.
Additional Considerations:
• If the device doesn't have a button (for example,
an on-off switch), press the rocker switch on the
device.
• If the device is the In-Wall
Scene/Group Controller
(Model CA5000), press
and hold (for 4+ seconds)
the
<HOME>
device. The Status Light on
the Hand-Held will:
- Blink BLUE once if programming is successful.
- Blink RED once if programming failed. If this
happens, try again. If it fails a second time,
refer to the Troubleshooting Section of this
Manual for additional information.
Providing a brighter solution.™
<EXCLUDE>
button on the device to be
<ACTIVATION>
button on the
Setting Up Your Network
button on
<HOME> <HOME>
button button
1
STATUS STATUS
LIGHT LIGHT