Issue
The Hand-Held falls
asleep while setting
up a scene.
Device does
not respond to
commands from the
Hand-Held.
A scene used to work,
but no longer controls
devices.
Scene creation causes
a RED light error.
Providing a brighter solution.™
Possible Solution
This is normal behavior.
1.
Finish setting up the scene.
Press the <HOME> button to wake the
2.
Hand-Held.
Press and hold the <SCENE SELECTION>
3.
button to complete the setup.
Exclude and re-include the device.
NOTE: The CA5100 cannot be controlled
by remote.
Recreate the scene.
Creating a new scene overwrites the
previous scene.
The Hand-Held or Base may be out of
range of the devices to be controlled.
Include additional devices to the network
to expand its range.
•
No devices were included in the scene,
so the scene was erased.
•
Try excluding and re-including all
devices in the scene to make sure they
are in the network.
•
Another device may already be in
"learn" mode.
•
Make sure that the Hand-Held is
included to the Base before using it in
the network.
•
The Base may be out of range of the
devices to be controlled. Include
additional devices to the network to
expand its range.
NOTE: The CA5100 cannot be controlled
by remote.
Troubleshooting
1