Activating A Scene - Intermatic InTouch CA5500R User Manual

Activating a Scene

when it "sees" them. This may take a few minutes as
the network sorts things out. When it's finished, set
the device as you want it for the scene.
4. Return to the controller. Press and hold (for
approximately 10 seconds) the button being
programmed. The Status Light will stay on while the
controller is gathering information, and will then:
• Blink BLUE once if programming is successful.
• Blink RED once if programming failed. If this
happens, try again. If it fails a second time, refer
to the Troubleshooting Section of this Manual for
additional information.
5. Test the programming. Press the
button once to select the scene, then press the
button to activate the scene. Press
<ENTER>
again to deactivate.
NOTE: If all of the devices in the scene are on, the
<SCENE SELECTION>
indicates that the status of the selected scene is ON.
That's all there is to it. Repeat the procedure to program
other buttons on the controller to create other scenes.
Once you've set up a scene by programming it with
your controller, use this procedure to activate it.
1. If using a Hand-Held, make sure the lights under the
Hand-Held's buttons are lit. If they are not lit, press
any button to wake the Hand-Held from battery-
saving sleep mode.
2. Press the
<SCENE SELECTION>
scene. The ring around the button will begin to pulse
with a blue light.
NOTE: More than one
be pressed to adjust several scenes at the same time.
If you want to deselect all the scenes selected before
making changes, press the
controller.
Providing a brighter solution.™
Programming Scenes with Controllers
button will be brightly lit. This
button that controls the
<SCENE SELECTION>
<HOME>
<SCENE SELECTION>
<ENTER>
button can
button on the