Connecting The Analyzer To A Modem - Teledyne 300E Instruction Manual

Operating Instructions
<CRLF> à END OF LINE: A carriage return-line feed pair always terminates the
message.
The uniform nature of the output messages makes it easy for a host computer to
parse them into a relatively easy to read structure.

6.9.5. Connecting the Analyzer to a Modem

The M300E can be connected to and operated over the Internet through a modem.
This requires a db-9 female to db-25pin male cable (available from T-API as p/n
WR0000024).
Once the cable has been connected, check to make sure the DTE-DCE is in the
correct position. Also make sure the model 300E COM port(s) are set for a Baud
Rate (see Section 6.8.5) that is compatible with your device and that your device
operates with an 8-bit word length wit one stop bit.
The first step is to turn on the MODEM ENABLE communication mode (see
Section 6.8.4). Once this is completed the appropriate SETUP command line for
your modem can be entered into the analyzer. The default setting for this feature
is:
AT YÆ &DÆ &HÆ &IÆ SÆ=2 &BÆ &N6 &MÆ EÆ Q1 &WÆ
100
Model 300E Carbon Monoxide Analyzer
Instruction Manual
P/N 04288 REV: A