Debug Platform Resource-Manager - Cisco WS-C3560E-24PD-E Command Reference Manual

debug platform resource-manager

debug platform resource-manager
Use the debug platform resource-manager privileged EXEC command to enable debugging of the
resource manager software. Use the no form of this command to disable debugging.
Syntax Description
all
dm
erd
errors
madmed
sd
stats
vld
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(19)EA1
Usage Guidelines The undebug platform resource-manager command is the same as the no debug platform
resource-manager command.
Related Commands Command
show debugging
Catalyst 3560 Switch Command Reference
B-60
debug platform resource-manager {all | dm | erd | errors | madmed | sd | stats | vld}
no debug platform resource-manager {all | dm | erd | errors | madmed | sd | stats | vld}
Display all resource manager debug messages.
Display destination-map debug messages.
Display equal-cost-route descriptor-table debug messages.
Display error debug messages.
Display the MAC address descriptor table and multi-expansion descriptor table
debug messages.
Display the station descriptor table debug messages.
Display statistics debug messages.
Display the VLAN-list descriptor debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Appendix B Catalyst 3560 Switch Debug Commands
78-16405-05