Setting Parameters; Directly Accessing The Parameters - SMA SUNNY ISLAND 3.0M Operating Manual

5 Operation of the Sunny Island Inverter with the Sunny Remote Control
3. Press the button.
☑ The Sunny Remote Control displays the sub-menu level. The selected menu level is shown in the first line.
4. Repeat steps 2 and 3 until the Sunny Remote Control displays the first parameter page.
5. Turn the button to the right until the Sunny Remote Control displays the desired parameter.
6. Set the parameter (see Section 5.4.6, page 34).
7. To exit the parameter page, switch to the higher level or switch to standard mode:
Useful hint: <back> and <home> also appear at the end of the list if the button is turned to the right.
• Turn the button to the left until the return symbol appears in the first line.
• To switch to a higher menu level, turn the button to the left until <back> appears.
• To switch to standard mode, turn the button to the left until <home> appears.
• Press the button.
<back> and <home> also appear at the end of the list if the button is turned to the right.
5.4.6

Setting Parameters

1. Switch to installer mode on the Sunny Remote Control (see Section 5.4.1, page 32).
2. Select the desired parameter. You can set only the parameters
for which < Set >
3. Press the button.
☑ The return symbol is flashing next to the value.
✖ Stop device to change the value appears in the display?
The parameter can be changed only in standby mode.
• Stop the system (see Section 4.3, page 20).
✖ No permission to change the value appears in the display?
You are not allowed to change the parameter in installer mode.
• If you want to change the parameters for the battery, select the menu New Battery in the QCG (see
Section 11.8 "Replacing the Battery", page 97).
• For all other settings, select the menu New System in the QCG (see the Sunny Island inverter
installation manual).
4. To set the parameter, turn the button to the left or right.
5. Press the button.
☑ The Sunny Remote Control requests confirmation of the set
parameter.
6. To confirm the value, turn the button to the right until Y is flashing and then press the button.
7. To discard the value, turn the button to the right until N is flashing and then press the button.
5.4.7

Directly Accessing the Parameters

Any parameter can be accessed directly by entering a five-digit number. The five-digit number is composed as follows:
• The first three digits are the menu number.
• The last two digits are the parameter number.
34 SI30M-44M-60H-80H-BE-en-33
is shown in the second line in the display.
SMA Solar Technology AG
Settings interter
210#01 (Set)
InvVtgNom
250.0 [V]
Settings interter
210#01 (accept Y/N)
InvVtgNom
230.0 [V]
Operating Manual