SMA SUNNY ISLAND 3.0M Operating Manual page 11

Sunny remote control
Hide thumbs Also See for SUNNY ISLAND 3.0M:
Table of Contents

Advertisement

SMA Solar Technology AG
To prevent personal injury and property damage and to ensure long-term operation of the product, read this section
carefully and observe all safety information at all times.
Danger to life from electric shocks due to live voltage and risk of injury from short-circuit currents
High voltages are present inside the Sunny Island inverter. When the enclosure lid is removed, live components can
be touched that can result in death or serious injury due to electric shock. Short-circuit currents in the battery can
cause heat build-up and electric arcs. Burns or eye injuries due to flashes may result.
• When carrying out any work on the electrical installation, wear suitable personal protective equipment.
• Switch off or disconnect the following components in the following order:
– Sunny Island
– The control and measurement voltages in the distribution board of the Sunny Island circuit breakers
– Load-break switch of the battery
• Ensure that the system cannot be reconnected.
• Open the enclosure lid of the Sunny Island and ensure that no voltage is present.
• Ground and short-circuit the AC conductors outside the Sunny Island inverter.
• Cover or isolate any adjacent live components.
Danger to life from electric shock due to damaged inverter
Operating a damaged inverter can lead to hazardous situations that can result in death or serious injuries due to
electric shock.
• Only use inverter when it is technically faultless and in an operationally safe state.
• Check the inverter regularly for visible damage.
• Make sure that all external safety equipment is freely accessible at all times.
• Make sure that all safety equipment is in good working order.
Risk of crushing injuries due to moving PV array parts
Moving parts in the PV array can crush or sever body parts. A generator can be started automatically by the
Sunny Island.
• Operate the generator only with the safety equipment.
• Carry out work on the generator in accordance with the manufacturer's specifications.
Risk of burns due to short-circuit currents on the disconnected Sunny Island
The capacitors in the DC connection input area store energy. After the battery is isolated from the Sunny Island,
battery voltage is still temporarily present at the DC connection. A short circuit at the DC terminal can lead to burns
and may damage the Sunny Island inverter.
• Wait 15 minutes before performing any work at the DC terminal or on the DC cables. This allows the capacitors
to discharge.
Operating Manual
SI30M-44M-60H-80H-BE-en-33
2 Safety
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sunny island 6.0hSunny island 4.4mSunny island 8.0h

Table of Contents