Setting Parameters - SMA FUEL SAVE CONTROLLER 2.0M User Manual

SMA Solar Technology AG
Button
Adjust
Apply
Continue Wizard
Delete config.
Discard
Done
Remove item
Start
View
4.8.3

Setting Parameters

Setpoints for the Subsystems
Basically you should always proceed as follows to set the value of a parameter. Note the instructions for the separate
subsystems according to the following table.
Subsystem
Utility grid
Gensets
PV power plant
Measurement devices
Digital inputs and outputs
Display of parameters with non-permitted values:
Symbol Designation
Error symbol
User Manual
Description
Adjust configuration of a subsystem
Save system settings
This saves all system settings in the active dialog. If you exit the active dialog
without saving the system settings, any system settings made since the last save
will be discarded.
Continue to the next dialog
Delete configuration of a subsystem
Discard system settings
Any system settings made in the active dialog and not saved by pressing the Ap-
ply button will be discarded.
Close the active dialog and switch to the overview of current system settings
Remove device type, e.g. a type of inverter
Start automatic configuration wizard
Show overview of current system settings
See
(see Section 7.1, page 37)
(see Section 7.2, page 37)
(see Section 7.3, page 41)
(see Section 7.4, page 43)
(see Section 7.5, page 47)
Explanation
If a parameter is set to a non-permitted value, it will be marked as invalid by this
error symbol.
4 User Interface
FSC20-BA-en-10 19