To Do The Incoming Inspection - Agilent Technologies 35670A Installation Manual

Agilent 35670A

To do the incoming inspection

The Agilent 35670A Dynamic Signal Analyzer was carefully inspected both
mechanically and electrically before shipment. It should be free of marks or scratches,
and it should meet its published specifications upon receipt.
1
Inspect the analyzer for physical damage incurred in transit. If the analyzer was
damaged in transit, do the following:
•
•
•
If the analyzer is mechanically damaged, the integrity of the protective earth
Warning
ground may be interrupted. Do not connect the analyzer to power if it is
damaged.
2
Check that the POWER SELECT switch on the analyzer's rear panel is set to the AC
position.
The switch is in the AC position when in the ''in'' position.
Save all packing materials.
File a claim with the carrier.
Call your Hewlett-Packard sales and service office.
Preparing the Analyzer for Use
To do the incoming inspection
2-5