Agilent Technologies 35670A Installation Manual page 5

Agilent 35670A Rear Panel
1-
The GPIB connector links the Agilent 35670A to other GPIB devices. GPIB parameters are set in the [ Local/GPIB ] and
[ Plot/Print ] menus.
2-
The SERIAL PORT and the PARALLEL PORT link the analyzer to plotters and printers. These parameters are set in the
[ Plot/Print ] menu.
3-
The SOURCE connector outputs the analyzer's source signal. An LED on the front panel indicates if the source is on or off. The
source parameters are set in the [ Source ] menu.
The standard Agilent 35670A (2-channel) also has a source connector on the front panel.
4-
The EXT TRIG connector links the analyzer to an external trigger signal. The external trigger parameters are set in the [ Trigger ]
menu.
5-
The TACH connector links the analyzer to a tachometer. The tachometer parameters are set in the [ Input ] menu.
6-
The KEYBOARD connector attaches an optional keyboard to the analyzer.
7-
The DC POWER connector accepts DC power levels from 12 - 28 Vdc (nominal).
8-
The AC POWER connector accept a wide range of ac voltage levels.
9-
The POWER SELECT switch determines whether the analyzer is powered via the AC POWER connector or the DC POWER
connector.
10-
The EXT MONITOR port links the analyzer to multi-sync monitors.
v