Verifying Specifications
To set up the source output resistance test
To set up the source output resistance test
Performance Test only
This test verifies that the Agilent 35670A meets its source output specification for
resistance. In this test, a digital multimeter measures the 50
termination. The channel 1 input then measures the source output across the
feedthrough termination, then in an open circuit condition. The resistance is
calculated using the following formula:
Rs = R1((Vopen - Vload)/Vload)
Note: Use the same 50
1
2 ch
2
2 ch
3-44
Ω
feedthrough termination for steps 1 and 2.
Agilent 35670A
Ω
feedthrough